Show:
  • Rako RLED150CV1 Wireless LED Dimmer

    £243.60

    The Rako RLED150CV1 wireless Single channel 150w Dimmer is a compact single channel 150W constant voltage LED dimmer with in-built RF receiver and Rako processor for control of single channel constant voltage LED tape light.

    The Rako RLED150CV1 is programmed using either a RCM/RCP RF wallplate or the RASOFT PC software suite, the unit stores the house, room and channel address plus 16 preset scene levels in non volatile memory. The RLED150CV1 dimmer can be controlled from any Rako transmitter such as RCM/RCP wallplates, RAH hand helds and Bridge modules and forms the foundation of any Rako scene-set system. For more information on dimming LEDs refer to Rako’s application sheet ‘Controlling LED Lighting With Rako Dimmers and Modules’.

    Add to cart
  • Rako RLED30 Slave Colour Booster

    £145.20

    For larger systems Rako RLED30 Slave would be used to extend or amplify your desired circuit. The RLED30 Slave is a 4 channel colour booster to be used with the RLED30CV4.

    The RLED30Slave is designed to work with RLED30CV4 modules where the length of tape exceeds the capacity of the RLED30CV4. The RLED30Slave is fed the output signal from the RLED30CV4 and allows a further length of tape to be controlled from the same base RLED30CV4 unit. This method of slaving is more cost effective than having multiple RLED30CV4 units but importantly allows colour cycling to remain in sync where multiple RLED30CV4 units may drift due to slight differences in the internal clocks.

    Add to cart
  • Rako RLED30CV4 4 Channel Wireless (RGBW) Driver/Controller

    £195.60

    The RLED30-CV4 is a wireless 4 channel, 30w/channel (Red, Green, Blue & White) constant voltage colour controller, For larger systems the Rako RLED30 Slave would be used to extend or amplify your desired circuit.

    A compact 4 channel 30W per channel, constant voltage LED dimmer with in-built RF receiver and Rako processor for control of 4 channel constant voltage LED fittings.

    Add to cart
  • Rako RLED45CC1 Wireless 45W Constant Current Dimming Module

    £174.00

    The Rako RELD45CC1 is a compact 45W constant current LED dimmer. Designed as part of the Rako Wireless range with built-in RF receiver and Rako processor for constant current LED fittings. To suite differing loads the RLED45CC1 has five selectable outputs of 350, 500, 600, 700 and 1000mA and a voltage range of 3-45V DC.

    Add to cart
  • Rako RLED75CV1 Wireless Single Channel 75w Dimmer

    £165.60

    The Rako RLED75CV1 is An in-line RF 75w single channel, constant voltage dimming LED driver. The compact single channel 75W constant voltage LED dimmer with in-built RF receiver and Rako processor for control of single channel constant voltage LED fittings. Controlled from any Rako Rakom device, e.g. RCP/RCM wall plates or Bridge interface units.

    Add to cart
  • Rako RML 500w Leading Edge Dimmers

    £164.40

    The Rako RML-500 (500w) RF Dimmer is designed to fit through the aperture of a standard low voltage down light fitting. The dimmer is connected in-line before the first light fitting, to enable dimming of up to 500w/250w of leading edge dimmable loads.

    Add to cart
  • Rako RML-1200 Leading Edge 1200W Wireless Dimmer Module

    £253.20

    For Flexible lighting control the Rako RML-1200 Leading Edge 1200W Wireless Dimmer Module is an inductive dimmer thaT can control up to 1200 watts of mains dimmable lighting loads. The unit can also be used for exterior lighting control applications, with the use of a weatherproof IP rated enclosure.

    Add to cart
  • Rako RMT-1200 Trailing Edge 1200W Wireless Dimmer Module

    £253.20

    The Rako RMT-1200 is a compact 1200W RF dimmer designed to be mounted in a ceiling void using an access panel or wall mounted in an electrical cupboard. The primary purpose of the RMT-1200 Trailing Edge Module is for  dimming GU10 LED lamps, tungsten, low-voltage halogen and other trailing edge dimmable loads.

    Add to cart
  • Rako RMT-500 Trailing Edge Dimmer

    £164.40

    The Rako RMT-500 is a trailing edge 500W ceiling-mount dimmer.The RMT500 uses trailing edge dimming technology to maximise the performance of most GU10 dimmable LED down-lights (refer to Rako Controls for compatibility and maximum loadings). The RMT500 is also the recommended dimmer for GU10 tungsten lamps due to its in-built short circuit protection, necessary with this style of lamps.

    Add to cart
  • Rako RMT-PILL Trailing Edge 250W Back Box Dimmer

    £164.40

    The Rako RMT-PILL is designed to offer flexible control and fits in to a standard UK or European back-box. A compact 250W RF dimmer designed to be located in a standard UK or European backbox. The RMT-Pill can be used either with or without a neutral allowing it to be used with dedicated wiring or retrofit into a standard wiring situation. Trailing edge technology for quiet reliable dimming of any non-inductive load when used with a neutral or tungsten GLS and tungsten halogen GU10 style lamps when used without. Controlled from any Rako Rakom device or simple contact closure input using a momentary push switch.

    Add to cart
Show: